Film Blowing Machine Heating Transformation Step

Film blowing machine heating transformation steps involve the following procedures:

1. Begin by removing the modified section of the original heater barrel.

2. Determine the appropriate size of the barrel, including its perimeter length, and calculate the necessary amount of heat preservation cotton. Additionally, estimate the power required for the heating coil winding based on the original location.

3. Proceed to wrap insulation cotton around the barrel, securely tying it with bandages. Maintain a heat preservation cotton thickness of approximately 1.5-2.0cm. For a more aesthetically pleasing installation, consider wrapping the heat preservation cotton with a 0.5mm layer of insulating resin plate.

4. Wrap the barrel with magnet wire, ensuring the winding is as tight as possible.

5. Finally, install the electromagnetic heating control cabinets.